4310 Excess temperature Fault in ABB ACS880 Drive

-

 How can resolve problem 4310 Excess temperature Fault in ABB ACS880 Drive ?

Cause : Power unit module temperature is excessive.

1. Check ambient conditions.

2. Check air flow and fan operation.

3. Check heatsink fins for dust pick-up.

4. Check motor power against drive power

click here for more information & other fault detail

Comments

Post a Comment

Popular posts from this blog

Fault 3381 in ABB ACS560 Drive

-
Image
  Fault 3381 in ABB ACS560 Drive ? 3381 fault is Output phase loss due to Motor circuit fault due to missing motor connection (any of the three phases not connected). 1.Check motor cable. If you run drive with motor of low rating motor as compare to drive then this fault comes. This fault can be disable by parameter Programmable fault: 31.19(Motor phase loss) - 0 (no action/disable) For more information click here
Read more

3210 DC bus overvoltage fault in lenze i550 drive

-
Fault Code 3210 in a Lenze i550 drive indicates a DC bus overvoltage fault . This means the voltage on the DC bus within the drive has exceeded its safe operating limit. Potential Causes Drive Internal Components: A fault in the drive's rectifier, smoothing capacitor, or control circuitry. Solution: This often requires professional inspection and repair or replacement of the faulty component. Power Supply Issues: Excessive AC voltage input to the drive. Solution: Check the power supply for voltage fluctuations or overvoltage conditions. Motor Issues: A short circuit or other fault within the motor can cause excessive back EMF, leading to DC bus overvoltage. Solution: Inspect the motor for any signs of damage or malfunction. Drive Configuration Issues: Incorrectly configured drive parameters, such as excessive regeneration or improper motor data. Solution: Review and adjust drive parameters to match the motor and application requirements. Troubleshooting Steps Check Power ...
Read more

FF06 Motor overspeed fault in lenze i550 drive

-
Fault Code FF06 in a Lenze i550 drive indicates a motor overspeed fault . This means the motor connected to the drive is spinning at a speed that exceeds its rated maximum speed. Potential Causes Drive Configuration Issues: Incorrectly set maximum speed limit or frequency. Solution: Verify and adjust drive parameters to match the motor's specifications. Mechanical Problems: Jamming or Binding: Obstructions in the mechanical system can cause the motor to accelerate beyond its rated speed. Loose Coupling: A loose coupling between the motor and the driven load can lead to overspeed. Solution: Check for mechanical obstructions, ensure proper alignment, and tighten couplings as needed. Sensor Issues: A faulty speed sensor or incorrect sensor calibration can provide inaccurate speed readings, leading to overspeed. Solution: Verify the sensor's functionality, calibrate it if necessary, or replace it if faulty. Drive Internal Components: A fault within the drive's contr...
Read more