alarm cooling

-

Cause : Drive module temperature is excessive.

1. Check ambient temperature. If it exceeds 40 °C (104 °F), ensure that load current does not exceed derated load capacity of drive.

2. Check drive module cooling air flow and fan operation.

3. Check inside of cabinet and heatsink of drive module for dust pick-up.

4. Clean whenever necessary.


Click here for more information

For all support Drives – click2electro Forum

Comments

Post a Comment

Popular posts from this blog

How to Fix Siemens SINAMICS Alarm A7991 Motor ID Selected?

-
Image
Seeing A7991 on your Siemens drive? This alarm means Motor Data Identification is selected. Learn how to start the ID run or clear the alarm in our guide.   Solving Siemens Alarm A7991: Motor Data Identification Selected If you are looking at your Siemens SINAMICS G120 or S120 drive and the display is flashing A7991 , you are in the final stages of setting up your motor. In the Siemens manual, this is defined as "Motor data identification selected." This isn't a "broken" state. It is the drive's way of saying, "I'm ready to measure the motor's electrical traits, but I'm waiting for you to tell me when to start." Let's look at why this appears and how to clear it so you can get back to production. Why is Alarm A7991 Appearing? The A7991 alarm is triggered when Parameter P1900 (Motor data identification and speed controller optimization) is set to a value other than 0. ...
Read more

How to Troubleshoot the "bb" (Baseblock) Error in Yaskawa VFDs

-
Image
Seeing the "bb" code on your Yaskawa drive? Learn what Baseblock means, common causes like external interlocks or safety circuits, and how to clear this status to get your motor running.   If you are working with a Yaskawa V1000, A1000, or GA700 drive and the display suddenly shows a flashing "bb" , you might think the drive has failed. However, "bb" is unique because it is often a status indicator rather than a permanent hardware fault. In the world of Yaskawa, "bb" stands for Baseblock . When this appears, the drive has cut off the power to the motor by "blocking" the firing of the internal transistors (IGBTs). The motor will coast to a stop, and the drive will refuse to start until the "bb" condition is cleared. Here is how to find out what is triggering it. What is a Baseblock (bb) Signal? Think of the Baseblock as a "Software E-Stop." It is an instruction given to the drive to immediat...
Read more

Fault 3181 in ABB ACS560 Drive

-
Image
  Fault 3181 in ABB ACS560 Drive ? 3181 fault in ABB ACS560 drive is wiring or earth fault due to Incorrect input power and motor cable connection (ie. input power cable is connected to drive motor connection) 1.Check power supply cable and motor cable. 2.Check input power connections. It is programmable fault: 31.23 Wiring or earth fault.(don't disable drive may be damage). For more information click here
Read more