F31117 fault in Siemens V70 Drive

-
F31117 fault in Siemens V70 Drive indicates an Inversion error on signals A/B/R. This means the differential (inverted) tracks from a square-wave encoder are missing or mismatched with the primary tracks. Cause: For a square-wave encoder (bipolar, double ended) signals A*, B* and R* are not inverted with respect to signals A, B and R.

Remedy:
  • Check the encoder/cable.
  • Does the encoder supply signals and the associated inverted signals?

Comments

Post a Comment

Popular posts from this blog

3210 DC bus overvoltage fault in lenze i550 drive

-
Fault Code 3210 in a Lenze i550 drive indicates a DC bus overvoltage fault . This means the voltage on the DC bus within the drive has exceeded its safe operating limit. Potential Causes Drive Internal Components: A fault in the drive's rectifier, smoothing capacitor, or control circuitry. Solution: This often requires professional inspection and repair or replacement of the faulty component. Power Supply Issues: Excessive AC voltage input to the drive. Solution: Check the power supply for voltage fluctuations or overvoltage conditions. Motor Issues: A short circuit or other fault within the motor can cause excessive back EMF, leading to DC bus overvoltage. Solution: Inspect the motor for any signs of damage or malfunction. Drive Configuration Issues: Incorrectly configured drive parameters, such as excessive regeneration or improper motor data. Solution: Review and adjust drive parameters to match the motor and application requirements. Troubleshooting Steps Check Power ...
Read more

FF06 Motor overspeed fault in lenze i550 drive

-
Fault Code FF06 in a Lenze i550 drive indicates a motor overspeed fault . This means the motor connected to the drive is spinning at a speed that exceeds its rated maximum speed. Potential Causes Drive Configuration Issues: Incorrectly set maximum speed limit or frequency. Solution: Verify and adjust drive parameters to match the motor's specifications. Mechanical Problems: Jamming or Binding: Obstructions in the mechanical system can cause the motor to accelerate beyond its rated speed. Loose Coupling: A loose coupling between the motor and the driven load can lead to overspeed. Solution: Check for mechanical obstructions, ensure proper alignment, and tighten couplings as needed. Sensor Issues: A faulty speed sensor or incorrect sensor calibration can provide inaccurate speed readings, leading to overspeed. Solution: Verify the sensor's functionality, calibrate it if necessary, or replace it if faulty. Drive Internal Components: A fault within the drive's contr...
Read more

7180 Motor overcurrent fault in lenze i550 drive

-
Fault Code 7180 in a Lenze i550 drive indicates a motor overcurrent fault . This means the motor connected to the drive is drawing more current than its rated capacity, which can lead to overheating and potential damage. Potential Causes Overloaded Motor: The motor is being asked to do more work than it's designed for. Solution: Reduce the load on the motor or ensure it's rated for the required power. Mechanical Issues: Jamming: The motor or its connected machinery might be jammed, causing excessive current draw. Friction: Increased friction due to misalignment or worn components can lead to higher currents. Solution: Check for mechanical obstructions, ensure proper alignment, and replace worn parts if necessary. Electrical Problems: Short Circuit: A short circuit within the motor windings can cause excessive current. Incorrect Wiring: Improper connections can lead to overloading. Solution: Inspect for short circuits, verify wiring diagrams, and correct any issue...
Read more